profinet-knx-converter-s7comm-knx-converter-vietnam.png

PROFINET / KNX - Converter S7comm / KNX - Converter Vietnam

This serie of products allows to integrate a PROFINET network with a KNX net.
In case of Siemens PLCs (or equivalent), it is possible to use S7comm protocol to get and set data into them from a KNX net. S7comm protocol is a Siemens protocol: this protocol is very good if it is necessary to get and set data from/to the PLC without changing the configuration of the PLC itself. This protocol will work as a debug protocol and the automation below the PLC will continue to work without any interferance.


The HD67818 is a PROFINET / KNX Converter and it allows you to connect a PROFINET net (for example a SIEMENS PLC..) with a KNX net (for example light switches, actuators..) in order to exchange the informations between the networks.


The HD67B79 is a PROFINET Master / KNX Converter and it allows you to connect a PROFINET net with a KNX net (for example light switches, actuators..) in order to exchange the informations between the networks.





The HD67628 is a S7comm / KNX Converter and it allows you to connect a KNX net (for example light switches, actuators..) with a Siemens PLC (or equivalent) in order to exchange the informations between the networks without changing the configuration and stopping the automation of the PLC.


These converters are very easy to configure and allows you to interface a PROFINET or S7comm system with the KNX world.
On KNX side you can connect all the common KNX devices such as temperature sensors, shutters, light switches, actuators, alarms etc.